Re: [B.A.T.M.A.N.] Switch backhaul based on connection

On Donnerstag, 14. Dezember 2017 12:20:48 CET Carlito Nueno wrote:

Hi all,

I have nodes A, B, C. On all nodes, wifi and lan are bridged. Also, they are all connected via mesh.

                                    |---> node B

ethernet <--> Node A <-- | | ---> node C

Node A is the exit node - connected via ethernet cable and node B and node C are connected to A via mesh.

So, when I connect node C via ethernet, does it start using ethernet as backhaul or still keeping mesh.

[...]

Sorry, this is not a batman-adv question. And it highly depends on your configuration. For example, the bat0 interface doesnt seem to be in the bridge. So I have to assume that you use routing - and thus you have to check your metric settings for each IP(v6) route.

And if everything is in a bridge then you have to check your bridge cost (and STP, ...) configurations.

Kind regards, Sven