On Donnerstag, 14. Dezember 2017 12:20:48 CET Carlito Nueno wrote:
I have nodes A, B, C.
On all nodes, wifi and lan are bridged. Also, they are all connected via mesh.
|---> node B
ethernet <--> Node A <-- |
| ---> node C
Node A is the exit node - connected via ethernet cable and node B and
node C are connected to A via mesh.
So, when I connect node C via ethernet, does it start using ethernet
as backhaul or still keeping mesh.
Sorry, this is not a batman-adv question. And it highly depends on your
configuration. For example, the bat0 interface doesnt seem to be in the
bridge. So I have to assume that you use routing - and thus you have to check
your metric settings for each IP(v6) route.
And if everything is in a bridge then you have to check your bridge cost
(and STP, ...) configurations.