I have following problem: I have two Asus wl500gp router, each with atheros(Atheros 5212) wlancards, running kamikaze 7.06; kernel ver.:2.6.19.2. and B.A.T.M.A.N. 0.2 rv451 (compability version 3) one of them has access to the internet. The one who has no internet connection, doesn't set a default route to the one who has. It only sets this routes:
Destination Gateway Genmask Flags Metric Ref Use Iface 192.168.33.23 0.0.0.0 255.255.255.255 UH 0 0 0 ath0 0.0.0.0 0.0.0.0 0.0.0.0 U 0 0 0 tun0 how can I fix it, or what did I wrong? here my are settings
On the router with the internet connection:
NIC: ath0 IEEE 802.11g ESSID:"muh" Nickname:"" Mode:Ad-Hoc Frequency:2.412 GHz Cell: 02:0B:6B:4E:17:DA Bit Rate:0 kb/s Tx-Power:16 dBm Sensitivity=0/3 Retry:off RTS thr:off Fragment thr:off Encryption key:off Power Management:off Link Quality=27/94 Signal level=-68 dBm Noise level=-95 dBm Rx invalid nwid:621 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0
ath0 Link encap:Ethernet HWaddr 00:0B:6B:4E:17:DA inet addr:192.168.33.23 Bcast:192.168.255.255 Mask:255.255.0.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:1759 errors:0 dropped:0 overruns:0 frame:0 TX packets:1720 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:91520 (89.3 KiB) TX bytes:89328 (87.2 KiB)
batmand: batmand -g 11 -r 0 ath0
batmand -c -d 1
Originator Router (#/128): Potential routers... [B.A.T.M.A.N. 0.2 rv451, MainIF/IP: ath0 192.168.33.23, UT: 0d 0h16m] 192.168.33.27 192.168.33.27 (128): 192.168.33.27 (128)
route:
Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 192.168.33.27 0.0.0.0 255.255.255.255 UH 0 0 0 ath0 10.147.112.0 0.0.0.0 255.255.255.128 U 0 0 0 eth0.1 192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 br-lan 192.168.0.0 0.0.0.0 255.255.0.0 U 0 0 0 ath0 0.0.0.0 10.147.112.1 0.0.0.0 UG 0 0 0 eth0.1
configuration of the router without internet connection:
NIC:
ath0 IEEE 802.11g ESSID:"muh" Nickname:"" Mode:Ad-Hoc Frequency:2.412 GHz Cell: 02:0B:6B:4E:17:DA Bit Rate:0 kb/s Tx-Power:16 dBm Sensitivity=0/3 Retry:off RTS thr:off Fragment thr:off Encryption key:off Power Management:off Link Quality=62/94 Signal level=-33 dBm Noise level=-95 dBm Rx invalid nwid:197859 Rx invalid crypt:0 Rx invalid frag:0 Tx excessive retries:0 Invalid misc:0 Missed beacon:0
ath0 Link encap:Ethernet HWaddr 00:0B:6B:4E:17:53 inet addr:192.168.33.27 Bcast:192.168.255.255 Mask:255.255.0.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:886366 errors:0 dropped:0 overruns:0 frame:0 TX packets:887894 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:46036433 (43.9 MiB) TX bytes:46196970 (44.0 MiB) # was set by batmand tun0 Link encap:UNSPEC HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-00-00 inet addr:192.168.33.27 P-t-P:192.168.33.27 Mask:255.255.255.255 UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1472 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:500 RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
batmand:
batmand -r 1 ath0
batmand -c -d 1
Originator Router (#/128): Potential routers... [B.A.T.M.A.N. 0.2 rv451, MainIF/IP: ath0 192.168.33.27, UT: 5d 0h28m] 192.168.33.23 192.168.33.23 (128): 192.168.33.23 (128)
batmanad -c -d 2
Gateway Router (#/128) => 192.168.33.23 192.168.33.23 (128), gw_class 11 - >6 MBit, reliability: 0
route:
Destination Gateway Genmask Flags Metric Ref Use Iface 192.168.33.23 0.0.0.0 255.255.255.255 UH 0 0 0 ath0 192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 br-lan 192.168.0.0 0.0.0.0 255.255.0.0 U 0 0 0 ath0 0.0.0.0 0.0.0.0 0.0.0.0 U 0 0 0 tun0
Hi,
I have two Asus wl500gp router, each with atheros(Atheros 5212) wlancards, running kamikaze 7.06; kernel ver.:2.6.19.2. and B.A.T.M.A.N. 0.2 rv451 (compability version 3) one of them has access to the internet. The one who has no internet connection, doesn't set a default route to the one who has. It only sets this routes:
it looks quite good so far. Blocked TCP is the most obvious reason that the tun device does not appear. the client tries to establish a TCP control channel (port 1967) to the gateway. If that connection attempt is ignored no default route will be set.
Regards, Marek
b.a.t.m.a.n@lists.open-mesh.org