On 30/05/14 11:22, Lucy Coya wrote:

Hi everyone, My name is Lucy Coya, I´m a telecommunications engineer and I need some help with my BATMAN configuration. I´m using batman-adv-2014-2.0 and batctl-2014-2.0 I´m trying to use BATMAN protocol in a very very simple routing scenario at first to study the protocol. I have: -Two Laptops using two wireless interfaces each (wlan0 in AP mode and wlan1 in Ad Hoc mode).

I meshed the two wireless interfaces in ad hoc mode according to the wiki steps and it worked fine,so I can ping the interfaces. Now I´m trying to make that two clients connected to the AP interfaces can ping each other through the mesh network. I tried creating a bridge between wlan0 and wlan1 as the wiki says but no ping :-(. I don´t know what to

you should bridge wlan0 (the AP interface) with bat0 and add wlan1 (adhoc) to bat0 with "batctl if add"

in ascii art that'd be: br-lan \ wlan0 \ bat0 \ wlan1

in bash commands that'd be

# add adhoc interface to bat0 batctl if add wlan1

# remove addresses from slave interfaces ip addr flush dev wlan0 ip addr flush dev wlan1 ip addr flush dev bat0

# bridge ap interface with bat0 brctl addif br-lan wlan0 brctl addif br-lan bat0

# add the ip address to the bridge ip addr add dev br-lan 2001:db8::1/64

cheers!

gui

do so any help would be awesome!!! Thanks Sorry if my English is bad :-)

Lucy

50 Aniversario de la Cujae. Inaugurada por Fidel el 2 de diciembre de 1964 http://cujae.edu.cu