-----Ursprüngliche Nachricht----- Von: "John Harris" <JHarris(a)web.de&gt; Gesendet: 31.12.08 13:24:46 An: dondavis(a)reglue.org Betreff: Re: [B.A.T.M.A.N.] Some questions to BATMAN

Hii Don, my scenario look like as follows... router 1 <---------------------> router 2 <-----------------------> router 3 (connected to server..IP 129.211.186.46) eth1:bat eth1:bat eth1:bat (11.1.1.2) (wired: 129.211.186.12) The IP Adress of my router 3 is 129.211.186.12 (dhcp-lan), router 3 is connected to my server with the server IP 129.211.186.46. I can ping the eth1:bat interface of the router among each other. But I couldn't make a trace to the server IP 129.211.186.46 from an another router... I get the message: " *sendto: Network is unreachable traceroute: wrote 129.211.186.46 40 chars, ret=-1" My settings to BATMAN are: ---------------------------------------- Management: B.A.T.M.A.N. WLAN as 11.1.1.3/24 LAN as 129.211.186.12 local internet-bandwidth: This is not a internet-gateway common used gateway stable Prefered gateway: Host&Network Announcement (HNA): 129.211.186.46/24 Visualisation Server: Hello-Interval [ms]: ---------------------------------------- The output of the command "batmand -c -d 1" on the router I see: Originator Router (#/128): Potential routers... [B.A.T.M.A.N. 0.2 rv502, MainIF/IP: eth1:bat 11.1.1.1, UT: 0d 1h22m] 11.1.1.3 11.1.1.3 (119): 11.1.1.3 (119) 129.211.186.181 11.1.1.3 (128): 11.1.1.3 (128) Originator Router (#/128): Potential routers... [B.A.T.M.A.N. 0.2 rv502, MainIF/IP: eth1:bat 11.1.1.3, UT: 0d 0h27m] 11.1.1.1 11.1.1.1 (124): 11.1.1.1 (124) I would be very appreciate, if you an the others could give me some advice how to fix my problem...How can make a traceroute form a router to the server IP 129.211.186.46. Thanks in advance... greetings, J > -----Ursprüngliche Nachricht----- > Von: "John Harris" <JHarris(a)web.de&gt; > Gesendet: 29.12.08 21:39:27 > An: b.a.t.m.a.n@open-mesh.net,dondavis@reglue.org > Betreff: Re: [B.A.T.M.A.N.] Some questions to BATMAN > Hiii Don, > > thank you very much for your reply, for your help... > > > > > >> 1) > >> I will build a mesh network.. One of my router is connected to my server > >> with the IP 129.211.186.12. I can't make > >> a traceroute through my router to this server. If I try to make > >> "traceroute 129.211.186.12" from an another router I get the message: > >> "PING 129.211.186.12 (129.211.186.12): 56 data bytes > >> ping: sendto: Network is unreachable > > > > > > router Server (129.211.186.12) > > (batman eth0) <------------------> (batman some wireless device) > > > > On the router, which firmware are you running with Batman? > > > > > > When you type batmand -c -d 1 on the router /server what do you see? > > > > What does batmand -v show on the router / server? > > > > > > I have some problems with my server at the moment, I will write the output of the other commands as soon as possible... > > > my freifunk firmware is v1.6.29 and the batmand version is :B.A.T.M.A.N. 0.2 rv502 (compability version 3) > > > > > > >> I can send ping requests from my server to the router and from the > >> router to the server, but as I said, I can't make a traceroute to the > >> server > >> from an another router. My question is, how can I do this ? > >> > >> In OLSR it was not a problem to trace the server through the router. > >> Should I change something in HNA messages ? > >> > >> 2) > >> I read the HowTO from Freifunk Leipzig about the configuration of > >> BATMAN, look here http://wiki.leipzig.freifunk.net/BATMAN. How is the > >> configuration > >> If I want to run BATMAN in Ubuntu Intrepid? How can I configure the > >> IPTABLES ? > >> > > > > For newer batman and experimental you'll want to open up ports 4305-4307: > > > > iptables -t filter -I INPUT 2 -p udp --dport 4305 --sport 4305 -j ACCEPT > > iptables -t filter -I INPUT 2 -p udp --dport 4306 --sport 4306 -j ACCEPT > > iptables -t filter -I INPUT 2 -p udp --dport 4307 --sport 4307 -j ACCEPT > > iptables -t filter -I OUTPUT 2 -p udp --dport 4305 --sport 4305 -j ACCEPT > > iptables -t filter -I OUTPUT 2 -p udp --dport 4306 --sport 4306 -j ACCEPT > > iptables -t filter -I OUTPUT 2 -p udp --dport 4307 --sport 4307 -j ACCEPT > > > You helped me a lot so far,thank you, > I will write the output of the commands as soon as possible... > > > greetings, > John > > > > > > > > > > > > _______________________________________________ > > B.A.T.M.A.N mailing list > > B.A.T.M.A.N(a)open-mesh.net > > https://list.open-mesh.net/mm/listinfo/b.a.t.m.a.n > > > _______________________________________________________________________ Täglich 1.000.000 Euro gewinnen! Jetzt kostenlos WEB.DE MillionenKlick spielen! https://millionenklick.web.de/?mc=mail@footer.mklick@home _______________________________________________ B.A.T.M.A.N mailing list B.A.T.M.A.N(a)open-mesh.net https://list.open-mesh.net/mm/listinfo/b.a.t.m.a.n