Hi,
I set up a wireless mesh network by setting batman-adv on three Raspberry pies.
There was no problem communicating with each other. (ping, iperf check completed)
However, I have disabled one of these batman-adv settings and rejoined the wireless mesh network.
As a result, only two raspberry pies that have set up batman-adv communicate.
is this right?
If so, how do I configure it so that non-batman-adv nodes and nodes with batman-adv enabled communicate with each other?
Best regards.
--- Kwang-Min Kim(kim25444@naver.com) +821055216393
On Montag, 30. April 2018 23:18:59 CEST KwangMin Kim wrote: [...]
However, I have disabled one of these batman-adv settings and rejoined the wireless mesh network.
As a result, only two raspberry pies that have set up batman-adv communicate.
is this right?
They still communicate in some sense with each other - just not on batman-adv and will thus not be able to reach services which run on top of batman-adv (for example some IPv4/v6 network).
If so, how do I configure it so that non-batman-adv nodes and nodes with batman-adv enabled communicate with each other?
https://www.open-mesh.org/projects/batman-adv/wiki/Quick-start-guide#Mixing-...
Kind regards, Sven
b.a.t.m.a.n@lists.open-mesh.org
-
KwangMin Kim -
Sven Eckelmann