On Thursday, 27 February 2020 16:13:48 CET Zach Barnett wrote:

I looking for clarification about the following question

How can I connect non-mesh clients to my batman-adv network ?

Bridge (easiest way) or route the traffic from non-mesh interface to the batadv interface (and vice versa). [1]

Does this mean that for an existing batman node to allow non-mesh clients to join (I.E. cell phone, wifi camera, etc..), then 2 interfaces are required?

Not necessarily but in most situation you want to use different (operation) modes for sending batman-adv and non-batman-adv traffic over wifi. But it is possible to use the same link layer interface. This is often the case when you want to use ethernet for transporting the batman-adv traffic and the client traffic.

Just keep in mind that you cannot directly bridge an interface and have it at the same time as batadv slave interface. So you have to split this interface up somehow.

For ethernet, it is recommended to put the batman-adv traffic in something like V(X)LAN on top of the ethernet device.

Other option could also be to use a macvlan on top of the ethernet interface - your ethernet interface just needs to support promiscious mode for receiving and allow to send with a different mac address. Then you have basically two virtual ethernet interfaces.

But you could even create fancy things with veth pairs. Put one end in the same bridge as the actual real ethernet interface. And then add the other end as slave to the batadv interface. And then you can put the batadv interface in the first bridge. You should most likely add some ebtables filter for 0x4305 ethernet frames at the correct positions. But I would call this "experimental".

Just keep in mind that all the bridging will not work with client mode interfaces (non-AP STA interfaces in infrastructure mode).

For example, if I have a pi-zero W in a wooded area, and I want a camera to connect to it, then do I need to add an additional usb network adapter to the Pi. One Interface for the Bat0 Mesh and One interface an an entry point for non-mesh clients.

I hope you are not talking about wifi usb network adapters. Because they are (often/always) quite shitty in non-infrastructure modes. And also often shitty in infrastructure mode in the AP role.

But regarding wifi PHYs under Linux - they usually support multiple virtual interfaces on the same PHY. Just check the interface combinations information from "iw phy"

Kind regards, Sven

[1] https://www.open-mesh.org/projects/batman-adv/wiki/Faq#How-can-I-connect-non...