ok it works now. i had to change "ath0" to "wlan1" at /etc/config/batman-adv.

thanks! xxiao

--- On Fri, 6/5/09, austinxxh-ath9k@yahoo.com austinxxh-ath9k@yahoo.com wrote:

From: austinxxh-ath9k@yahoo.com austinxxh-ath9k@yahoo.com Subject: [B.A.T.M.A.N.] ath9k and batman-adv To: b.a.t.m.a.n@open-mesh.net Date: Friday, June 5, 2009, 11:05 PM

I'm trying to use batman-adv with ath9k/openwrt. two boards(each board has one ath9k card and one ath5k card), ath9k on both boards are configured at the same channel(5), then I did : #echo wlan1 > /proc/net/batman-adv/interfaces on each of the board, however #cat /proc/net/batman-adv/originators showed up nothing.

Note: I have wlan0 with ath5k for AP, on different channels. I also have eth0 with local IP address but I did not add it to batman-adv.

I then tried to configure bat0 with IP address and then ping, of course it did not work.

anything else that I am missing here? anyone had success with ath9k/batman-adv?

thanks! xxiao _______________________________________________ B.A.T.M.A.N mailing list B.A.T.M.A.N@open-mesh.net https://lists.open-mesh.net/mm/listinfo/b.a.t.m.a.n