Good Day all, I have Wireless DSL router and Open Mesh Router. Is it possible to bridge the Open Mesh Router with Wireless DSL router wirelessly to get the internet?
Thank You
Thank You for your reply. Yes however it runs B.A.T.M.A.N mesh protocol. I wonder. is it possible to do it?
If yes, what configuration/commands i have to do?
Regards,
On 15 March 2011 21:11, Sven Eckelmann sven@narfation.org wrote:
On Tuesday 15 March 2011 18:58:16 A. AlBoori wrote:
Good Day all, I have Wireless DSL router and Open Mesh Router.
Open Mesh router == a router from open-mesh.com? We are not related to open-mesh.com
Kind regards, Sven
It is unlikely your dsl modem can run any mesh protocol. (The Open-Mesh OM1P runs "Robin", which uses olsr)
However, if you have the Open-Mesh OM1P device, you can reflash it with OpenWrt and turn it into a WDS repeater, assuming your dsl modem supports this.
Your best source of information on robin and OM1P is here: http://robin.forumup.it/
OM1P as a generic AP is discussed here: http://robin.forumup.it/about1534-robin.html
If you have the newer Open-Mesh MR500, you are out of luck. That firmware is not open-source.
On 3/15/2011 11:19 AM, A. AlBoori wrote:
Thank You for your reply. Yes however it runs B.A.T.M.A.N mesh protocol. I wonder. is it possible to do it?
If yes, what configuration/commands i have to do?
Regards,
On 15 March 2011 21:11, Sven Eckelmannsven@narfation.org wrote:
On Tuesday 15 March 2011 18:58:16 A. AlBoori wrote:
Good Day all, I have Wireless DSL router and Open Mesh Router.
Open Mesh router == a router from open-mesh.com? We are not related to open-mesh.com
Kind regards, Sven
Tom Cannon wrote:
It is unlikely your dsl modem can run any mesh protocol. (The Open-Mesh OM1P runs "Robin", which uses olsr)
Why do you want to run it as mesh? Maybe this wireless router can be configured as station. Or both devices can be configured to support 4 address mode. But this would mean that this is off topic.
But I don't have any information about the hw - so I cannot make any useful statements at all.
Kind regards, Sven
On Tuesday 15 March 2011 19:19:00 A. AlBoori wrote:
Thank You for your reply. Yes however it runs B.A.T.M.A.N mesh protocol. I wonder. is it possible to do it?
Yes, batman-adv allow bridging your LAN into your WLAN.
Please contact open-mesh.com to learn how to do so: http://www.open-mesh.com/contacts/
Regards, Marek
b.a.t.m.a.n@lists.open-mesh.org
-
A. AlBoori -
Marek Lindner -
Sven Eckelmann -
Tom Cannon