Hi Folks
I'm working on a mesh project with some nodes which are nomadic. I need to know the location of each node, so i can do map overlays. So these nomadic nodes have GPS and i'm distributing the location information over Alfred, with a new server/client binary. I also have stationary nodes, and a simulation system, without GPS, so i have support for passing location via the command line.
The code needs some more testing, a man page, but release early, release often, so here it is.
Comment welcome.
Andrew
Andrew Lunn (1): alfred: Add support for passing location information over alfred.
CHANGELOG | 3 + Makefile | 24 ++- README | 52 +++++- gpsd/Makefile | 81 ++++++++ gpsd/alfred-gpsd.c | 529 +++++++++++++++++++++++++++++++++++++++++++++++++++++ gpsd/alfred-gpsd.h | 102 +++++++++++ 6 files changed, 784 insertions(+), 7 deletions(-) create mode 100644 gpsd/Makefile create mode 100644 gpsd/alfred-gpsd.c create mode 100644 gpsd/alfred-gpsd.h
On Wed, Oct 02, 2013 at 06:25:51PM +0200, Andrew Lunn wrote:
Hi Folks
I'm working on a mesh project with some nodes which are nomadic. I need to know the location of each node, so i can do map overlays. So these nomadic nodes have GPS and i'm distributing the location information over Alfred, with a new server/client binary. I also have stationary nodes, and a simulation system, without GPS, so i have support for passing location via the command line.
The code needs some more testing, a man page, but release early, release often, so here it is.
Comment welcome.
Andrew
Did you accidentlly send this E-mail a second time? I'm a little bit confused, it has the same PATCHv1 and no patches following (btw, if it's just one patch you probably don't need a cover letter. I don't care too much though)
Simon
On Thu, Oct 03, 2013 at 04:25:07PM +0200, Simon Wunderlich wrote:
On Wed, Oct 02, 2013 at 06:25:51PM +0200, Andrew Lunn wrote:
Hi Folks
I'm working on a mesh project with some nodes which are nomadic. I need to know the location of each node, so i can do map overlays. So these nomadic nodes have GPS and i'm distributing the location information over Alfred, with a new server/client binary. I also have stationary nodes, and a simulation system, without GPS, so i have support for passing location via the command line.
The code needs some more testing, a man page, but release early, release often, so here it is.
Comment welcome.
Andrew
Did you accidentlly send this E-mail a second time?
Yes. When sending the RFC patch, i went back in my bash history for the git send-email command used previously, and accidentally sent the cover note patch before i noticed my error.
Andrew
b.a.t.m.a.n@lists.open-mesh.org
-
Andrew Lunn -
Simon Wunderlich