Hello,
On Montag 24 September 2007, Michael Burmeister-Brown wrote:
Marek,
I hate to bother you but you were so responsive before...
Antonio just put up a post. We are both seeing the same problem - computers associated with repeaters on 0.3 (MIPS) can't browse. But ssh into that node and do a wget and it works great!. If we just replace 0.3 with 0.2 all works again.
So you want to use the batman-clients as APs for usual 802.11-managed-mode clients. If I understand you right, then you prbably need to do network address translation (NAT) or MASQUERADEing on the bat0 interfaces on the batman clients. And of course a second time on the batman-GW.
Also, I am tracking memory and see it dropping steadily on the nodes (500k in about 12 hours). This didn't happen with 0.2 and that is all that has changed.
Thats interesting, sounds like a memory leak, because in the lates setups i tested the memory consumption was constantly 3.1 percent (even after hours). using dynamically compiled mipsel binaries and up to 20 nodes . Can you send the output from top right after the start, after a few minutes and after a few hours. And the output of debug-level -5 (hope its compiled in)
ciao, axel