David Beaumont wrote:
The bat0 interface is currently bridged as follows
On the router with internet going into the WAN port (ETH1), BAT0 is bridged with the LAN (ETH0) Internet works correctly though the lan, so i would assume NAT routing to the WAN is setup correctly?
so you have eth0 and bat0(ath0) in a bridge br0 -> eth1 uses nat to translate packets for/from eth1?
On the router on the other end of the mesh, BAT0 is bridged with the WAN port (ETH1) so that the router will route WAN traffic though BAT0?
What? Why a different internet gateway and why do you bridge the bat0(ath0) interface with the wan interface instead of using nat here?
Maybe there is a misunderstanding somewhere... At least I am extremely confused about your setup.
Best regards, Sven