Re: [B.A.T.M.A.N.] B.A.T.M.A.N L2 over a Bluetooth PAN

Hello Breno,

as far as i know, for 802.11 the SNAP protocol is used to encapsulate the complete Ethernet Frame [1]. This means that the Ethernet header is completly preserved and can be decapsulated on the receiver side. The BNEP protocol on the other hand seems to cut off the Ethernet header instead of encapsalutating it when i understand the specification correctly [2, page 13]. However the examples [2, page 15 and page 41] suggest that the Ethernet Header is encapsulated completly within BNEP.

For batman-adv a correct Ethernet Header, especially correct MAC Addresses to identify the peers and support for our specific Ethernet Type is needed. If these fields are not (re-)generated correctly, it won't work.

So the question is: is BNEP even transporting arbitrary frames with Ethertypes other than IP (0x0800)? Maybe there are some filters preventing the BATMAN frames (type 0x4305) to be transported [2, page 42]?

I guess a good starting point would be to use some bluetooth dump tools or tcpdump, inject packets and see if they are received on the peer site. Maybe just some filter is preventing batman-adv from operation. :)

best regards, Simon

[1] http://osnet.inm.nchu.edu.tw/powpoint/seminar/802.11/802.11MAC.pdf (slide 28) [2] http://grouper.ieee.org/groups/802/15/Bluetooth/BNEP.pdf

On Thu, Feb 12, 2009 at 11:42:44PM -0300, Breno Jacinto wrote:

Hello,

I'm experimenting on heterogeneous ad hoc networks, which today

are still very restricted in terms of hardware availability for off-the-shelf devices. Actually, the two most common technologies available today are 802.11 and Bluetooth, being this last one able to form simple personal area networks in the form of piconets.

 In practical terms, the BlueZ stack of the Linux allows the

formation of Bluetooth PANs consisting of up to 8 nodes, but it's an incredibly difficult process - actually, the piconet master needs to bridge connections so that all other devices in the network, which depend on this master, are able to reach it other directly - or at least feel like they are doing that. In fact, everything is just an emulation, since Bluetooth is a connection-oriented technology.

 BNEP (Bluetooth Network Encapsulation Protocol) is the piece

responsible for emulating an Ethernet network over Bluetooth, and theoretically any IP and above protocols can be used. Trying with simple IP broadcasts over a Bluetooth network shows that it works, but the problem comes when I try to do "straight" layer 2 broadcasts (not coming from the IP layer), such as the ones that BATMAN L2 does.

I tried to run BATMAN and add the interfaces used on each device -

pan0 for the master, which is a bridge device, and bnep0 for the slave, but the frame dont seem to reach any destination on the network. The originators table remains empty on both sides of the connection. Running Wireshark shows the frame being generated, but never reaching anyone.

So, I still cannot figure out why this is happening. I'd like to

know if anyone has adventured in doing something similar and succeeded.

best regards,

--

:: Breno Jacinto :: :: breno - at - gprt.ufpe.br :: :: FingerPrint :: 2F15 8A61 F566 E442 8581 E3C0 EFF4 E202 74B7 7484 :: Persistir no difícil é a única maneira de torná-lo fácil algum dia. :: _______________________________________________ B.A.T.M.A.N mailing list B.A.T.M.A.N@open-mesh.net https://lists.open-mesh.net/mm/listinfo/b.a.t.m.a.n