On Thu, 2018-10-18 at 08:22 +0200, Sven Eckelmann wrote:
On Donnerstag, 18. Oktober 2018 13:53:44 CEST gary wrote:
I setup a testbed like this. (BBN = backbone node)
Switch ---------->BBN1 --------------->MP1 | ------->BBN2---------------->MP2
MP1 and MP2 may select BBN1 or BBN2 as gateway. On both MP1 and MP2, I enable Alfred and batadv-vis as follows: alfred -i br0 -4 224.0.0.1 -m & batadv-vis -i bat0 -s
Looks like you are using the experimental IPv4 support which I don't want to actively support. So Jonathan Haws should take care of this.
I am aware of this issue, but was under the impression I was the only one it affected. I'm working on a fix (basically check the ARP table and if a record doesn't exist for the MAC then run an ARP query; if that query fails then report a error) and I hope to have it working soon.
when I run batadv-vis again on MP1, I can't get the info from MP2. If I ping the ip address of MP2 from MP1, MP1 will get MP2's mac address by arp. And then I run batadv-vis again, I can get the data from MP2 now.
Is there any configure or method to get MP2's info without ping test?
We have been working around this issue in the same manner as you describe for the time being.
Thanks, Jon