Hi,
I use batman advanced ("# batctl o" says "B.A.T.M.A.N. adv 0.2.1-beta r1578") on OpenWrt trunk and I have the following problem:
I have a wlan meshnetwork in ahdemo mode which uses batman. The meshnetwork is used by clients without batman and therefore I have another network on the same wifi device in ad mode which is bridged with bat0. The bridge is in the network 10.18.1.0/24.
I think its like described in http://www.open-mesh.org/wiki/batman-adv-quick- start-guide
The problem is, that I have a vpn network on tap0 (10.18.0.0/24) and I dont know how I can link this two networks/interfaces to each other with batman. I tried to assign tap0 to batman, but this doesnt work.
I want to be able to ping hosts that uses batman in the vpn and in the wlan network. How can I do this?
My configs look like this:
--------------- /etc/conf/network --------------- config 'interface' 'loopback' option 'ifname' 'lo' option 'proto' 'static' option 'ipaddr' '127.0.0.1' option 'netmask' '255.0.0.0'
config 'interface' 'lan' option 'proto' 'dhcp' option 'ifname' 'eth0'
config 'interface' 'mesh' option 'type' 'bridge' option 'ifname' 'ath0 bat0' option 'proto' 'static' option 'ipaddr' '10.18.1.101' option 'netmask' '255.255.255.0'
config 'interface' 'vpn' option 'proto' 'none' option 'ifname' 'tap0'
--------------- /etc/conf/wireless --------------- config wifi-device wifi0 option type atheros option channel 6
config wifi-iface option device wifi0 option mode ahdemo option bssid 02:CA:FF:EE:BA:BE
config wifi-iface option device wifi0 option mode ap option ssid oldenburg.freifunk.net
--------------- /etc/conf/batman-adv-kernelland --------------- config batman-adv-kernelland general option interface 'ath1 tap0' option originator_interval option log_level
thanks Floh1111