-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1
Freifunk Dresden wrote:
If I have multiple connections between two nodes, is there a way to setup the quality or priority of those connection?
Same goes for Leipzig, we have our vpn[1,2].leipzig.freifunk.net nodes. I thought about this problem a lot and the simplest solution would be to simply drop like 9 of 10 batman packets on the outgoing vpn interface. this is like a olsr multiplicator of 10 with the advantage that it saves bandwith.
short anecdote about dropping olsr packets: so, we now have this huge vpn that connects most edges of the mesh to central olsr nodes. because this are just backup routes, we have to increase the etx value, no problem with the olsr multiplier option. on the vpn a packetloss of 0% ist relative normal, so you pump out 5kb/s of olsr traffic just to say: mmhh, ok, very good connection but i think its bad anyway. so, if olsr messures the packet loss rate, i could simply drop 9 of 10 packets and with 0.5kb/s i would have the same effect. if that is what olsr is supposed to do.
by the way, we have arround 400 GB per month olsr overhead alone, which is just creazy for a routing protocol overhead.
i ran a couple of tests. there is a iptables match called nth, so i tested to allow only every tenth packet. i got a etx of 0.0 strange: i allowed 50% -> etx 0.0 stranger: i allowed 90% -> etx 0.0 there is a percent match. i combined them, i tried percent alone, etc. olsr depends a lot about which packets get dropped. you simply can't just drop packets without getting etx 0.0 for at least periods of 20-30 seconds, which drives you nuts.
batman should work very well with that approach.
kindly regards Daniel