On Thursday 23 June 2016 15:40:53 Sailash Moirangthem wrote:
My wireless configuration is:
config wifi-iface wmesh option device radio1 option ifname adhoc0 option network mesh option mode adhoc option ssid mesh option bssid 02:ca:ca::ca:40 option encryption none
So, it is almost the same as mentioned in [1] https://www.open-mesh.org/projects/batman-adv/wiki/Batman-adv-openwrt-config
Yes, I tried batctl if add adhoc0, and when i put batctl if.. it days adhoc inactive.
Please show the output of "iw dev", "iw phy", "ip link" and "batctl if" after you did the "batctl if add adhoc0".
Nothing critical says in dmesg. One line is to increase the mtu from 1500 to 1532 for eth0.
Hm, this retracted information is not telling the whole story. You are most likely not telling us about the other batman-adv messages. These for example would tell us what interfaces are added/removed/activated/...
Kind regards, Sven