[B.A.T.M.A.N.] about mesh network with batman-adv

Hi,

I set up a wireless mesh network by setting batman-adv on three Raspberry pies.

There was no problem communicating with each other. (ping, iperf check completed)

However, I have disabled one of these batman-adv settings and rejoined the wireless mesh network.

As a result, only two raspberry pies that have set up batman-adv communicate.

is this right?

If so, how do I configure it so that non-batman-adv nodes and nodes with batman-adv enabled communicate with each other?

Best regards.

--- Kwang-Min Kim(kim25444@naver.com) +821055216393