Hello again nice folks, I updated today another segment of the network with just 4 nodes, to batman-adv 2012.2 (the one i compiled yesterday with simon patches for blaII, marek stability fixes, and debug log enabled , yikes!) and i couldn't get batman to work over wired ethernet?? (?)
P -(50mts wlan)- D -----(ubnt transparent bridge) 2km -- C ----eth-------------------/
Node P and D connected by ethernet on eth0 but close enough that could also see each other through adhoc wlan, with bla enabled, correctly preferred ethernet connection to communicate between them (iperf yielded 92mbps), so far so good. now, node D and C, too far away from each other to communicate over wlan, but connected by a "loooong eth cable" (mediated by a wds transparent bridge) wouldn't find each other batman originator. C originator table was empty, and D only showed P. I thought the transparent bridge was misbehaving, so I tried in a simpler setup using P and D, with the wifi off: but after disabling wlan0 (batctl if del wlan0-2) and adding eth0 (batctl if add eth0) on both nodes, batman could not see each other anymore :( i thought i was doing something wrong, so i tried in different ways, but could not get it to work. batctl td eth0 shows both outgoing OGMs from local , and incoming OGMs from remote, but batctl l only reported outgoing OGMs.
diego is local node ("D"), palmeras is on the other side of the ethernet cable ("P") (and jure is further away, connected to palmeras by adhoc wlan, not illustrated in the previous ascii art)
i hope i'm overlooking something really obvious?
Have a nice weekend!
Gui