On Thursday, 11 July 2019 05:44:07 CEST Ricardo Cerrato wrote:
I recently configured a mesh with two nodes running Debian and batman-adv and two wireless adapters TP-LINK TL-WN422G configured in IBSS mode, and to allow non-mesh clients (like my cellphone) to use the mesh I had to use another wireless adapter (same TL-WN422G) configured in AP mode and bridged to the mesh interface (bat0). Recently I found in the FAQ:
"Can batman-adv run on interfaces in AP / Station / etc mode ? Q: Can BATMAN advanced run on interfaces in AP / Station mode? A: Yes, because batman-adv doesn't know anything about stuff below the ethernet interface. So you could also use it over layer 2 ethernet tunnels, wifi ap, wifi sta, wifi adhoc, ethernet or even write a virtual interface which prints everything on paper and scans the paper on the remote machine (but you should be fast or increase the ogm interval)."
I guess it is possible use the same adapter as AP and mesh client..
Yes, but this is a question for the linux-wireless folks. And the FAQ entry doesn't talk about this at all. You want to run AP and IBSS (which most likely doesn't work with your adapter; search for vif and interface combinations) in parallel and the FAQ entry talks about running batman-adv on top of something which is not IBSS.
I my tests I found the AP mode and IBSS modes are mutually exclusive, but I didn't find examples on how to create a mesh without IBSS...
There are plenty of examples out there which for example use 11s/meshpoint (with mesh_fwding set to 0) as an actual useful way to run batman-adv without IBSS. Just create the AP as normal and then create the the secondary vif for the mesh. It seems like most adapters today support meshpoint better than IBSS and thus you can just try to switch your underlying mode from IBSS to meshpoint. I also posted the commands to create a meshpoint interface on this mailing list a while back [1].
You can then just add the meshpoint interface to batman-adv and use it like IBSS (just with the difference that it is NOT IBSS).
But this doesn't seem to be batman-adv related question but questions for the linux-wireless community.
[...]
valid interface combinations:
- #{ managed, P2P-client } <= 2, #{ AP, mesh point, P2P-GO } <= 2, total <= 2, #channels <= 1
Here you can see that you can for example run an AP interface and mesh_point (just make sure that you disabled mesh_fwding) at the same time. batman-adv would run on top of the meshpoint interface.
Btw. you will most likely observer some odd behavior when you try to scale the mesh - these are most likely caused by the limitations [2] of the usb wifi stick.
Kind regards, Sven
[1] https://lists.open-mesh.org/pipermail/b.a.t.m.a.n/2015-December/013924.html [2] https://wireless.wiki.kernel.org/en/users/drivers/ath9k_htc