The bat0 interface is currently bridged as follows
On the router with internet going into the WAN port (ETH1), BAT0 is bridged with the LAN (ETH0) Internet works correctly though the lan, so i would assume NAT routing to the WAN is setup correctly?
On the router on the other end of the mesh, BAT0 is bridged with the WAN port (ETH1) so that the router will route WAN traffic though BAT0?
Have i got some of the basics confused somewhere?
I had BATMAN (not advanced) working fine, although was experiencing i think a known problem with openwrt, whereas when traffic was sent over the TUN interface for the captive portal the gate0 interface would collapse. Lets stay on topic with batman advanced for now though i guess :-)
On Thu, Aug 12, 2010 at 12:31 PM, Marek Lindner lindner_marek@yahoo.de wrote:
Hi,
I see the request for the page going over the bat0 interface and being received at the other end.
I've a feeling this is a basic nat problem, but have been unable to find a solution.
how is the routing (especially bat0) configured on the node that is connected to the internet ? Are you bridging bat0 or doing something else ?
Regards, Marek