cool....i set it up that way...i have each of the cards on different channels...so every board has ath0 and ath1 each tuned to a different channel....
so some boards are reachable on channel X whereas others on channel Y
however when i check the /proc/net/batman-adv/originators....i see that all other nodes are reachable but the interface mentioned is ath1....(even those which are actually reachable by ath0)
shouldn't some of the boards be reachable by ath0 - as some nodes are on a different channel...
or is it like ath1 is some main interface.....
On Thu, Feb 12, 2009 at 6:53 AM, Simon Wunderlich simon.wunderlich@s2003.tu-chemnitz.de wrote:
Hello Gargi,
yep, thats exactly the way to go. :)
best regards Simon
On Wed, Feb 11, 2009 at 09:06:46PM -0600, Gargi Purohit wrote:
Hi
I was wondering if I can run L2 batman kernel module on hardware which has 3 wireless cards. Should be process be the same as in adding interfaces e.g. ath0, ath1, ath2 to /proc/net/batman-adv/interfaces (where ath0, ath1, ath2 are different wireless cards) and adding bat0 with eth0 to the bridge?
Regards
Gargi _______________________________________________ B.A.T.M.A.N mailing list B.A.T.M.A.N@open-mesh.net https://lists.open-mesh.net/mm/listinfo/b.a.t.m.a.n
-----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.6 (GNU/Linux)
iD8DBQFJlBvbrzg/fFk7axYRAtgKAKDu6Wnm㨍跿䇹῁㫯ꝧ婙ꌀ⟛� dFuChjqLqYH/dXsbdAqH9vU= =/7Tb -----END PGP SIGNATURE-----
B.A.T.M.A.N mailing list B.A.T.M.A.N@open-mesh.net https://lists.open-mesh.net/mm/listinfo/b.a.t.m.a.n