Hi,
I have found that the batmand-experimental (rev1003) still consumes more and more memory if you have specified the -r1 or -r2 options. I haven't tried -r3. If I turn off gateway with option -r0 the memory consumtion is constant. It seems that the memory increase is in steps of 16kbyte but the time when this happens is different.
the syslog does not show any hint despite of several tries to name the bat0 interface (about ever two minutes): Mar 16 14:50:49 (none) kern.err bmxd[2133]: Startup parameters: /sbin/batmand -s 10.12.0.1 -a 10.12.10.16/28 -r 1 --t 63 --no-unreachable-rule --no-throw-rules --no-prio-rules --one-way-tunnel 1 --two-way-tunnel 0 eth1 tbb /t 1 /i /A Mar 16 14:52:27 (none) kern.err bmxd[2398]: Trying to name tunnel to bat0 ... Mar 16 14:52:27 (none) kern.err bmxd[2398]: success! Mar 16 14:54:04 (none) kern.err bmxd[2601]: Trying to name tunnel to bat0 ... Mar 16 14:54:04 (none) kern.err bmxd[2601]: success!
Both interfaces eth1 and tbb are active and conntected. The WRT54 that has the option -r0 set, has a constant memory consumtion.
During this test I got a very strange message on the wrt that only has the eth1 interface. There is no other router with the same ip address.
Mar 16 14:52:21 (none) kern.err bmxd[21119]: Drop packet: DAD alert! OGM from 10.12.10.17 via NB 10.12.10.17 with out of range seqno! rcvd sqno 28347, last valid seqno: 23290 at 6096067! Maybe two nodes are using this IP!? Waiting 0 more seconds before r Mar 16 14:52:22 (none) kern.err bmxd[21119]: Drop packet: DAD alert! OGM from 10.12.10.17 via NB 10.12.10.17 with out of range seqno! rcvd sqno 28348, last valid seqno: 23290 at 6096067! Maybe two nodes are using this IP!? Waiting 0 more seconds before r
Setup:
laptop-tbb-----------tbb[10.12.0.17]eth1--------eth1[10.12.10.1] | | | +------------tbb[10.12.10.17]eth1---------+
/stephan