On Wed, Aug 17, 2011 at 4:10 AM, John Tobias firstname.lastname@example.org wrote:
I have two devices, both of them have eth0, wlan0. I followed the BATMAN quick start guide (http://www.open-mesh.org/wiki/batman-adv/Quick-start-guide) mixing non-BATMAN. The bat0, eth0, wlan0 on both devices were set to 0.0.0.0 and the mesh-bridge on dev1 was set to 192.168.10.1 and on dev2 was set to 192.168.10.2. Both devices can ping to each other.
When I execute "batctl gwl", I was getting "No gateways in range ...".
My question is, do you have a sample step-by-step procedures to bring up the batman correctly?.
Firstly , what makes you think Batman is not up correctly? Then, I'm sure we can make more sense of your problem if you explain your network, you talk about two devices, that can ping each other, The simplest, is Bat0 which runs on Wlan0, So configure bridge on only Eth0 and bat0, thus anything on eth0, will see bat0(AKA, batman network) transparently. No need for GW. If clients get DHCP from anywhere, they should get the gateway details.