[B.A.T.M.A.N.] Problem after configuring a bridge

Hello *, I set up batman-adv-2010 on OpenWRT (backfire 10.3.x). Mesh interface is wlan0 and another non-batman-LAN is connected to eth0. non-batman clients should connect via the eth0 interface. (Full description and network diagram here: https://forum.openwrt.org/viewtopic.php?pid=129226#p129226 ). After setting up batman-adv 2010.x with batctl if add wlan0 ifconfig wlan 0 0.0.0.0 ifconfig bat0 192.168.10.2 (previous ip address of wlan0) ifconfig bat0 up I have to configure a bridge (according to quick start guide http://www.open-mesh.org/wiki/batman-adv-quick-start-guide) because I want batman-adv to announce MAC-addresses connected to eth0 (see network diagram): brctl addbr mesh-bridge brctl addif mesh-bridge eth0 brctl addif mesh-bridge bat0 ifconfig eth0 up ifconfig bat0 up ifconfig mesh-bridge up Although the translation tables (global and local) seem fine in this moment, at the same momentof bringing up the bridge I cannot send any more packets through bat0 or ent0. Both don't even reply to a ping. Network setup and outputs of ifconfig onhttp://www.open-mesh.org/wiki/batman-adv-quick-start-guide Any hint is appreciated. Stefan